AttoPilot Users Group

Smarter Cheaper Faster

Sending $T*54 to fire the trigger output.

Hi everyone,

Has anybody tried sending $T*54 or $T*FF to fire the trigger over a modem (X-Tend)
I have tried a few different ways but can't get it to work.
Please let me know if this works for you and how you did it.

Thanks!

Views: 15

Comment by Dean Goedde on September 17, 2009 at 19:48
Make sure:
1) the (ascii 13) is included after the checksum
2) the modem buffers are not clogged.
Comment by Dean Goedde on September 27, 2009 at 19:25
Also ensure that in SET you have the proper trigger controller (logic or servo PWM driver) and if a servo driver then the two positions are in SET, AND also (finally) that the trigger duration is setup in SET. if you still have problems e-mail me at dmgoedde@ gmail.com

Also, what version of firmware does your LOG tell you that your atto has? We might need to get you updated if you have a very old AttoPilot firmware. (when did you buy your Atto?)
Comment by Scott James on November 1, 2009 at 22:49
Only a month late for the reply from me but......
You were right Dean!
When I changed the over air rate on the X-tend up to 115,200 it started to work.
Dam those clogging modem buffers. :)

Add a Comment

You need to be a member of AttoPilot Users Group to add comments!

Join AttoPilot Users Group


Locations of visitors to this page

© 2017   Created by Gary Mortimer.   Powered by

Badges  |  Report an Issue  |  Terms of Service